Battborg

Can I fit a triborg into a pibow rainbow box I want to fit a adafruit Screen or something similar fitted to pibow and also use battborg to power it from 8 AAs would it be better to put the screen into the pi then run the cables out the side of the screen then connect triborg using a ribbon and run jumpers to battborg would this work OK

piborg's picture

I do not believe that a TriBorg will fit directly inside a Pibow case, even without a screen attached.

Fitting a TriBorg onto the ribbon cable instead should work fine, you my need to plug the cable on to the top of the TriBorg instead if it has a connector with holes instead of pins.

You can happily attach the BattBorg to any of the TriBorg headers in the same way you would the Raspberry Pi GPIO header itself.

Subscribe to Comments for "Battborg"